Haier 70 Pint Electronic-Control Dehumidifier review

The Haier HEN70ETF is an earlier 70-pint/day portable dehumidifier with an 18-pint front bucket, two fan speeds plus Smart Dry, and a gravity-only direct-drain route. It is the non-pump sibling to the HEN70ETFP: the shared cabinet and rating do not make their drainage interchangeable. Haier says HEN70ETF is no longer manufactured, so this page is an owner and exact-model reference rather than a current buying recommendation.

Sources personally checked: the Haier HEN70ETF page, its matching support record, the model-cover HEN70ET/HEN70ETF Installation and User Manual and the 2020 U.S. Haier catalog. The exact support record dates manufacture March 2018–January 2020.

Seventy pints does not mean an unattended bucket

Haier lists a 70-pint daily rating and an 18-pint bucket. The cabinet is 24 inches high by 15.12 wide and 10¾ deep; its listed net weight is 43.8 pounds. Compared with the HEH50ET, it is taller, heavier and holds seven more pints in the tank, but its bucket still cannot contain a full day at the nominal rating. A bucket-only owner should plan to check the full indicator and audible alarm rather than estimating a day’s use from the capacity label. The unit stops when full and resumes only after the tank is emptied and correctly seated.

The exact product page lists two manual fan speeds and Smart Dry. That gives a simple manual choice plus an automatic humidity-responsive mode, not a third manual speed. Haier lists high/low airflow of 170/148 CFM, 820 watts, 7.5 amps at 115 volts, and R410A refrigerant. The product page identifies HEN70ETF as ENERGY STAR qualified. These are manufacturer numbers; there is no independent room-performance or sound test here, and a standardized rating cannot promise a particular energy bill or moisture removal rate.

Gravity only: confirm where the drain sits

The HEN70ETF manual allows a direct drain if you want continuous operation near a floor drain. Its installation page says to remove the rear cover and rubber stopper, connect a separate garden-hose-style drain hose, lower the hose to the drain, and keep the collection bucket inserted correctly. The hose is not supplied. The route must descend to the outlet; there is no pump in the exact HEN70ETF specifications and no pump setup in the manual. The unit cannot be counted on to push condensate up to a utility sink, window or elevated standpipe.

This is the key suffix boundary. Haier’s adjacent HEN70ETFP page describes a built-in pump and supplies a 16-foot drain tube, but the HEN70ETF manual cover lists HEN70ET and HEN70ETF—not the pump suffix. HEN70ETF owners cannot inherit the pump’s tube or function from a similar front image, family listing or neighboring model number. If your outlet is raised, look for a current exact model with a published pump route and lift rating; HEN70ETF’s lift field remains unknown, so it fails any essential pump-height need.

Controls, cold-room caution and care

The manual sets a practical minimum: below 54°F the evaporator may frost and the machine enters periodic defrost, and if the room stays below 41°F it should be turned off. It recommends at least 8 inches of open space around the cabinet and says not to operate without the washable filter. Allow air to enter at the rear and leave through the top; leave room in front to extract the bucket. If the machine has been tilted, wait the manual’s stated 24 hours before restarting to allow oil to return to the compressor.

The rear filter should be vacuumed or washed and allowed to dry before it is reinstalled. Unplug the appliance before cleaning; do not spill liquid onto the controls or wash the cabinet with a hose. The filter captures ordinary dust, not a specialty contaminant, and nothing in these specifications supports a medical or mold-remediation claim. The 18-pint tank and caster base help with routine movement, but the empty unit is already over 43 pounds before adding water. Plan a stable, level placement and do not carry a full bucket through stairs.

When this earlier model still matters

HEN70ETF is a useful identification reference if the exact nameplate matches a unit already in a basement or a seller’s listing. For a smaller cabinet, the HEN30ET review explains the 30-pint rating and 7-pint tank; for a shorter 50-pint option, compare the HEH50ET. For the pump sibling, read the separate HEN70ETFP recall-focused review and do not treat it as a purchase alternative. All four exact Haier pages say their models are no longer manufactured; a seller’s listing does not establish warranty, service, unit condition or safe serial-number status.

If you need a current 70-pint dehumidifier, use the finder and filter by the water route you can actually install. A lower drain may make a non-pump model practical; a raised outlet demands a documented pump arrangement, not just a 70-pint rating. HEN70ETF’s published facts help distinguish a known earlier gravity model, but they are not a claim that this exact appliance is available or suitable for every damp room.